Replacing halogen downlights with LED is about more than the fitting — clearance, insulation, driver location and coverage all decide whether the room works afterwards.
Tell us the job — we come back with a fixed price.
Old 50W halogens run hot enough to cook insulation and ceiling timbers. A LED replacement cuts the load on the circuit by roughly eighty per cent, which often fixes a lighting circuit that has been tripping, and removes the heat problem. We remove the transformer where there is one, terminate properly, and check the fitting’s clearance rating against what is above it.
How many, how far apart, and what beam angle decides whether a room is evenly lit or looks like a runway. Kitchens, bathrooms and living areas need different answers, and bathroom and outdoor zones have specific requirements for what can be installed where.
LED drivers and dimmers do not always agree, which shows up as flicker, buzz or a limited dimming range. We match the dimmer to the driver rather than fitting a dimmer and hoping.
Sensor lights, floodlights and garden lighting — installed with the right IP rating, on a circuit that can be isolated, and aimed so they light the property rather than the neighbour’s bedroom.
Sometimes. Many older dimmers are not compatible with LED drivers and cause flicker or buzzing. We check compatibility and replace the dimmer where needed.
Yes — every fitting has a clearance requirement to insulation and building elements. It is stamped on the fitting and it is checked during installation.
It depends on ceiling height, room use and the fitting's output. We lay it out from the room rather than fitting the same number everywhere.