AirSolar Power

Solar Inverter Repair & Replacement

An inverter that has shut down takes the whole array with it. We diagnose whether it is the inverter, the DC side, the grid supply or the isolation — and replace only when replacement is the answer.

Licence 1513126 Fixed quote before work starts Southeast Queensland

Get a fixed quote

Tell us the job — we come back with a fixed price.

Common inverter faults

  • No display and no output after a power interruption
  • Earth fault or insulation alarm — often a damaged DC cable or water in a connector
  • Grid voltage alarms tripping the unit off in the middle of the day
  • Derating, overheating, or a fan that has failed
  • Communication loss — the system works but the monitoring is dead
  • Out-of-warranty failure where the manufacturer no longer supports the model

How we work through it

Isolate, test the array and the DC isolators, check the AC side and the grid supply, then read the unit’s own fault log. A surprising number of “dead inverter” calls are an isolator, a tripped circuit or a grid over-voltage event, all of which are cheaper to fix than a new unit.

Replacement

If the unit has failed and is out of warranty, the replacement has to match the array’s string configuration and the battery, if there is one. We quote the unit and the installation separately so you can see what the hardware costs, and we handle the network notification where a like-for-like change requires it.

Systems installed by someone else

We attend systems we did not install. Expect us to check the original work as part of the diagnosis, because DC isolator placement, cable protection and connector type are where a lot of failures start.

Common questions

Can a failed inverter be repaired rather than replaced?

Sometimes — fans, communication boards and isolators are replaceable. Power-stage failures on older units usually are not economic to repair, and we say so rather than billing diagnosis twice.

My system shows zero generation but the inverter is on. What now?

Usually an isolator, a tripped AC circuit, or the array side has been disconnected by a fault. It needs testing rather than resetting repeatedly.

Do you do warranty paperwork?

We provide the fault report and installation details you need to lodge a claim with the manufacturer or the original installer.